This self adhesive, plastic moulded T-piece fixes to the back of a standard three pin plug, and provides leverage for removing the plug from the socket. Supplied in a pack of 3. Also useful for drawers and doors where extra leverage is required. Weight 40g.
A coated wire cradle that holds most styles of jug kettle, and pivots on a raised wire frame by gentle pressure on the handle to assist with pouring. The kettle sits in the cradle and is secured by an elasticated strap. The frame has a built in stop for positioning the mug and a back stop to prevent spillage if the kettle is accidentally released during pouring. The frame has non-slip feet. Not suitable for cordless or mini jug kettles. Weight 602g.
A durable one-piece injection moulded board with raised L-shape in one corner. This allows bread to be spread using one hand. Size 181 x 256mm (71/8 x 101/8"). Weight 190g.
This hardwood board is fitted with non-slip feet, and six stainless steel spikes to grip bread or vegetables, when cutting one handed. It also has an L-shaped lip in one corner to allow one handed spreading of the cut slices.
325 x 175mm (123/4 x 7"). Weight 972g.
A tap turner with a wooden handle and plastic head designed to suit both cross bar or crystal style tap handles. Should the tap be of slightly larger diameter than the adaptor slots it is possible to fit the adaptor by immersing the prongs in near boiling water for approximately 30 seconds and gently pressing the slots on to the tap handle to mould it to shape. Allow to cool before removing.
Suitable for cross head tap.
Suitable for crystal head tap.
This device is used to give good leverage for turning small difficult items eg. gas or radiator taps. The head has a bed of sprung stainless steel rods, which when pressed around an object, retract, conform around its shape, and provide a purchase around it when the handle is turned. The handle is a black plastic T-piece, which is easy to grip. It is small enough to be carried around in a pocket or hand bag. Head size 95mm (33/4") wide. 50mm (2") deep. Weight 130g.
An adjustable plastic lever style tap turner with sliding steel pins that conform to the tap. The pins can adjust to hold different taps in place. Each time it is used the pins individually conform to the tap.
For use on capstan and most cross-head taps, these durable nylon tap turners, with their comfortable rectangular handles, simply fit over the tops of taps to give greater leverage and thus make taps easier to turn on and off. The turners can be left permanently in position – with the red over the hot and the blue over the cold. Can be operated with either hand or elbow. Also useful when travelling. Will fit most 'X' taps and are virtually unbreakable.
